Welcome to Garter's Web

FEATURES

After get the tubular roll from Circular Loom, put on un-winder unit with edge position control (EPC) pass through corona treatment unit into T-die laminating first side, after that fabric back and pass turn bar device to turn other side upward again through corona treatment into T-die for second side laminating, so this latest design need one T-die only, after T-die center slitter silting the film between both laminating side then trimming two side-end of bag with auto trimming device that equipped photo sensor to follow the side-end of bag, after that winding the fabric into roll and equipped auto change over system to easy operating without stop running.

 

T-Die
Corona
Auto Side Trimming Cutter
Winder
Control Panel

TECHNICAL SPECIFICATION

Model

GT-LA95-18SD (Perforation)

Usage

Single side coating for PP/HDPE woven fabric
Double side coating for PP tubular woven fabric

Production Width

850~1650 mm (single side)
400~780 mm (double side)

Production Thickness

0.02~0.05 mm

Line Speed

25~80 M/min

Output Capacity

160~180 kg/hr

Laminator

EPC Edge Cutting Device

1 SET

Middle Cutting Device

1 SET

Pre-Heating Roller

1 SET

Teflon Tape Belt Device

3 SETS

Corona Treating Machine

1 SET

Winder

Max. Diameter X Width

Ø1200 mm x 1800 mm (L)

Cutting & Roll Change Device

1 SET

T-Die

Die Width

1850 mm

Edge Reclaiming Device

1 SET

Unwinder

Max. Diameter X Width

Ø1200 mm x 1800 mm (L)

Auto Tension Controller

1 SET

Powder Brake

2 SETS

Edge Position Controller

1 SET

Perforation Roller Device

1 SET

Operation Electric Control Panel

Synchronous speed control

Other Equipment

Water Chiller

1 SET

Mixer

1 SET

30 Ton Cooling Tower

1 SET

Water Pump

1 SET

Air Compressor

1 SET